Edimax-technology Edimax user guide Router Manual de usuario descargar pdf (Pagina 26)

Page 22

Settings – Load Balance

Load Balance

Configuration

• Enable – Use this to enable your Load Balance settings. Unless this is

checked, the other settings on this screen have no effect.

• Balance Type – Select the desired option:

• Bytes rx+tx – Traffic is measured by Bytes.

• Packets rx+tx – Traffic is measured by Packets.

• Sessions established – Traffic is measured by Sessions.

• IP Address – Traffic is measured by IP address.

• Loading Share on WAN 1 – Enter the percentage (%) of traffic to be sent

over WAN 1. If one WAN port connection has greater bandwidth than the

other, the one with the greater bandwidth should be given a higher percentage

of traffic than the other.

Click the "Update" button to save your changes.

NAT

Statistics

This section displays the current data about WAN 1 and WAN 2. You can use this

information to help you "fine-tune" the settings above.

Interface

Statistics

This section displays cumulative statistics.

Use the "Restart Counters" button to restart these counters when required.

Buttons

• Update – Save the settings on this screen.

• Refresh – Update the data on screen.

• Restart Counters – Restart the counters used in the "Interface Statistics"

section.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 80 81

Sin comentarios

Edimax-technology Edimax user guide Router Manual de usuario Pagina 26