Edimax-technology PS-1206MFG Manual de usuario descargar pdf (Pagina 129)

121

To configure the IP address data for the BOOTP server, you will need to log in

the host of BOOTP server as the superuser (root). Perform the following steps

to add address entries,

1. Optionally, assign a name corresponding to the MFP Server’s IP address.

You can add this address to the /etc/hosts file, by adding a line such as:

203.66.191.12 pserver

2. Add an entry to the host’s /etc/bootptab file, similar to the following:

hostname:\

:ht=1:\

:ha=MFP_Server_ethernet_address:\

:ip=MFP_Server_ip_address:

Lines should be indented with tabs.

Where hostname is the device name of a MFP Server, the ht=1 tag

specifies the hardware type is Ethernet, the ha= tag specifies the Ethernet

address of a MFP Server, which is the Node ID located on the MFP Server.

The ha tag must be preceded by the ht tag. The ip= tag should correspond

to the IP address you want to assign to the MFP Server.

For example, a MFP Server with the following configuration:

Node ID: 0000B4010101 (this implies Ethernet address is 0000B4010101),

IP address: 203.66.191.12

The entry for this MFP Server in the /etc/bootptab file should be:

MF010101:\

:ht=1:\

:ha=0000B4010101:\

:ip=203.66.191.12:

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 141 142

Sin comentarios

Edimax-technology PS-1206MFG Manual de usuario Pagina 129